333 Install the Front Panel Assembly

Use the following procedure when installing the Front Panel Assembly:

1. Snap the Front Panel Assembly into place in the four tab retainers ("B").

2. Observing the alignment orientation provided by tabs on the connector, attach the display ribbon cable connector ("A") on the Main PCA.

3. Attach the wires at the rear of the front panel input terminals. Observe the following color coding:

• At the rear of the 100 mA input terminal, carefully insert the spring (attached to the white wire) into the fuse holder.

• Using needle nose pliers, connect the wires at the rear of the input terminals as follows:

VD^ Red

• Install the front panel 100 mA input fuse (F1).

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment