414 Continuity Hysteresis Threshold Calibration Front Panel

Perform the calibration as follows:

1. If the meter is already in calibration mode, press the (^B or button to select V^^ calibration. Otherwise, select calibration mode first (press Cal Enable button for three seconds), then select V^^ calibration by pressing the (^B button seven times.

2. Connect the output of the dc voltage source to the VH^^ and COM input of the meter.

3. Apply the outputs indicated in Table 4-5, and calibrate using the A button.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment