22Ext Option Menu and Functions

EXT OPTION

FREEZE MSG

OFF/ON

ANGLE RESET

OFF /ON

FAN FULL MODE

OFF / ON

AUTO SETUP

STANDARD / SPECIAL

SYNC

STANDARD / SPECIAL

VGA60/480p

AUTO / VGA60 / 480p

SELF CHECK

TEST PATTERN

FLICKER ADJUST

HPLL

OFF / ON

Switching ON/OFF "FREEZE" on-screen display

Switching ON/OFF "Realtime Keystone" reference level setting Note:

- Normally, do not select. (Angle reset data will be rewritten.)

Setting the cooling fan motor rotation speed

- Switching ON "FAN FULL MODE", the rotation level of the fan becomes high-speed rotation (fixed). Moreover, when "FAN FULL MODE" is ON, changing "HIGHLAND" in OPTION becomes impossible (setting "FAN FULL MODE" is given priority more than "HIGHLAND").

Setting AUTO SETUP mode

- STANDARD: To set the normal mode (the dot clock is adjusted strictly))

- SPECIAL: To set the special mode (the dot clock is adjusted roughly) Note:

- Do not change the initial setting (STANDARD).

Setting SYNC processing mode

- STANDARD: To set the normal mode

- SPECIAL: To set the special mode (noise reduction mode) Note:

- Do not change the setting when it is possible to receive normally.

Change the setting only when the image is not displayed normally because of the sync signal noise of connected equipment.

-AUTO: Switching RGB of VGA60 and 480p automatically

- VGA60: Inputting signals in 59.9Hz / VGA480

- 480p: Inputting signals in RGB of 480p

To enter the self-check mode

To enter the service mode

■ FLICKER ADJUST

To enter the flicker adjustment mode

When non-standard signal of VIDEO/S-VIDEO is inputted (VTR, VHD, etc.), horizontal synchronization might be disordered according to connected equipment. In this case, set HPLL to OFF.

Was this article helpful?

0 0

Post a comment