Product type Model Video system

Display method DMD panel


Projection lamp Component input signal (INPUT1/2)

Horizontal resolution Computer RGB input (INPUT 1/2)/output (OUTPUT) signal

S-video input signal (INPUT 3)

Video input signal (INPUT 4) Vertical frequency Horizontal frequency Pixel clock RS-232C terminal Audio input signal Audio output signal (AUDIO OUTPUT 1-4) Speaker system Rated voltage Input current Rated frequency Power consumption

Power consumption (standby) Heat dissipation

Operating temperature Storage temperature Cabinet I/R carrier frequency Dimensions (approx.)

Weight (approx.) Replacement parts

Projector DT-100



Single Chip Digital Micromirror Device™ (DMDTM) by Texas Instruments

Panel size: 0.53", 1chip DMD

275 W DC lamp

15-pin mini D-sub connector

Y: 1.0 Vp-p, sync negative, 75Q terminated

520 TV lines (DTV720P)

15-pin mini D-sub connector

RGB separate/sync on green type analog input: 0-0.7 Vp-p, positive, 75 Q terminated HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative) VERTICAL SYNC. SIGNAL: Same as above 4-pin mini DIN connector

Y (luminance signal): 1.0 Vp-p, sync negative, 75 Q terminated

C (chrominance signal): Burst 0.286 Vp-p, 75 Q terminated

RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Q


45-85 Hz

15-70 kHz

12-108 MHz

9-pin mini DIN connector

03.5 mm minijack or RCA terminal: 0.5 Vrms, more than 22 k Q (stereo) 03.5 mm minijack: 0.5 Vrms, less than 2.2 k Q

4 cm x 2.85 cm oval x 1 AC 100-240 V 3.6 A 50/60 Hz

350 W (Lamp Setting 305 W (Lamp Setting 330 W (Lamp Setting 285 W (Lamp Setting 4 W (AC 100 V) - 5 W (AC 240 V) 1,315 BTU/hour (Lamp Setting "Bright")/ 1,145 BTU/hour (Lamp Setting 1,240 BTU/hour (Lamp Setting 1,070 BTU/hour (Lamp Setting 41 °F to 95°F (+5°C to +35°C) -4°F to 140°F (-20°C to +60°C) Plastic 38 kHz

12 13/32" x 4 19/64" x 11 1/32" (315 (W) x 109 (H) x 280 (D) mm) (main body only) 12 13/32" x 4 47/64" x 1 1 37/64" (315 (W) x 120 (H) x 294 (D) mm) (including adjustment foot and projecting parts) 8.6 lbs. (3.9 kg)

Remote control, Power cord for U.S. and Canada, 3 RCA to 15-pin D-sub adaptor, Operation manual


"Eco + Quiet") with AC 100 V "Bright")/

"Eco + Quiet") with AC 100 V "Bright")/

As a part of policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

Was this article helpful?

0 0

Post a comment