Control Cables

The MAT-100 requires a control cable consisting of between 4-5 wires of at least AWG24 guage. The cable must be shielded.

1. Connect the 6-pin plug to rear of the radiotelephone.

TT; Antenna Coupler control GND; Ground

+ 13.6 VDC power supply

TS; Antenna Coupler control

ANT.C; Antenna current drain used to display the current drain on the display panel of the radiotelephone.

A 5 wire control cable is needed if you want to connect the ANT.C pin. Please refer to the MAT-100 Service Manual for further information on this function.

2. Strip the other side of the cable as shown below.

Tkm 707 Manual

+ 13.6 VDC power supply

TS; Antenna Coupler control

Rubber cap

Ground

Tighten to seal off from salt water spray.

Control cable

Ground

Tighten to seal off from salt water spray.

Control cable

4. Connect thru case of the Antenna coupler to Antenna connector of the radiotelephone with coaxial cable.

TYPICAL INSTALLATION

13.6 VDC

Transceiver

1 Antenna coupler

Boat earth i

+2 0

Post a comment